Details:
- 1500 lb Break Strength
- 500 lb Working Load Limit
- Manufactured in the USA
Product Weight: 4.68 lb
$57.49 Each
Looking for Reseller or Volume Pricing? Give us a call at 1-877-360-5528
PRODUCT NOTES:
- Rack-strap, Rack-strap Tie-downs, J Hook On One End
- Rack-Strap Tie-Down, Mountable Ratchet Strap For Truck And Van Ladder Racks, Includes Adapter For Use With Specific Crossbar Only Van Racks
- The Rack-Strap And Adapter Are Designed So The Tie-down Is Permanently Mounted And Always Ready For Use
- For Proper Use, The Strap Is Pulled Out From The Spool, Fed Under The Ladder Or Cargo, Brought Back Over The Cargo Untill The Hook Reaches Back To The Rack-Strap Frame. The Hook Is Then Connected To The Frame On The Front Pin And Ratcheted Tight
- Rack-Strap Offers Two Tightening Options, The Provided Tightening Rod Or 1/2 Inch Nut On The End Of The Drive Axle
- The Black Knob Is Provided As A Method Of Winding Up The Loose Strap Or Removing Any Slack, But Never Use The Knob To Tighten The Tie-down
- Rack-Strap Mounting Bracket Is The Low Profile Right Angle Configuration That Fits The Provided Van Adapter Pre-drilled Mounting Holes
- Rack-strap Frame Is Made Of Steel And Has A Zinc-yellow Plated Finish For Superior Weather Protection
- J Hook On The End Of The Strap Is The Double J Configuration And Has A Special Back Bend To Fit The Rack-Strap Frame
- Double J Hook Is Made Of Steel And Has A Zinc-yellow Plated Finish For Superior Weather Protection
- All Attached Rack-Strap Hardware Has A Zinc-yellow Plated Finish
- Van Adapter Is Made Of Steel And Has A Black Powdercoated Finish
- Strap Is Made With 4500 Lb Polyester Tie-down Webbing
- Sewn With Silver Polyester Thread
- Strap Length Is Measured As The Total Maximum Length When The Strap Is Fully Extended From The Frame
- Sewn In The Standard Method To Meet The Provided Strength Rating
- RS302 Van Rack Adapter Is A Single Bar Adapter Designed To Mount On 1.5 Inch Wide Square Tubing. 1.5 Inch Wide Tubing Is A Common Metal Size Used To Form The Crossmember Of The Van Rack. The Adapter Has Two Perpendicular Flanges Welded On The End That Fit Over Van Rack Tubing. There Are Pre-drilled Holes In The Adapter Flanges For Mounting To The Ladder Rack. The Opposite End Of The Adapter Has Pre-drilled Holes For Bolting On The Rack-Strap. The Van Adapter Is Designed To Fit Van Ladder Rack Models Such As
- Adrian Steel Cross Bar Only 1BAR, 2BAR, 3BAR Series Van Racks
- Rack-Strap Brand Strap Warning Label Sewn On The Hook End Of The Strap
- The Product Is The Rack-Strap Tie-down And Adapter Only, It Does Not Include The Bolt Mounting Kit
-
There are no special warnings for this product. Please see our Safety Warnings page for standard product warnings.
