HOME
PRODUCT NUMBER : 6385
|
|
|
$59.99 per each |
| PRODUCT MODEL: |
RS31K-K8J-B |
|
|
|
|
|
Looking for Reseller or Volume Pricing? Give us a call at 1-877-360-5528 |
 |
|
|
SEE ALL VARIATIONS OF PRODUCT 6385
|
PRODUCT NOTES:
- Rack-strap, Rack-strap Tie-downs, J Hook On One End
- Rack-Strap Tie-Down, Mountable Ratchet Strap For Truck And Van Ladder Racks, Includes Adapter For Use With Specific Crossbar Only Van Racks
- The Rack-Strap And Adapter Are Designed So The Tie-down Is Permanently Mounted And Always Ready For Use
- For Proper Use, The Strap Is Pulled Out From The Spool, Fed Under The Ladder Or Cargo, Brought Back Over The Cargo Untill The Hook Reaches Back To The Rack-Strap Frame. The Hook Is Then Connected To The Frame On The Front Pin And Ratcheted Tight
- Rack-Strap Offers Two Tightening Options, The Provided Tightening Rod Or 1/2 Inch Nut On The End Of The Drive Axle
- The Black Knob Is Provided As A Method Of Winding Up The Loose Strap Or Removing Any Slack, But Never Use The Knob To Tighten The Tie-down
- Rack-Strap Mounting Bracket Is The Low Profile Right Angle Configuration That Fits The Provided Van Adapter Pre-drilled Mounting Holes
- Rack-strap Frame Is Made Of Steel And Has A Zinc-yellow Plated Finish For Superior Weather Protection
- J Hook On The End Of The Strap Is The Double J Configuration And Has A Special Back Bend To Fit The Rack-Strap Frame
- Double J Hook Is Made Of Steel And Has A Zinc-yellow Plated Finish For Superior Weather Protection
- All Attached Rack-Strap Hardware Has A Zinc-yellow Plated Finish
- Van Adapter Is Made Of Steel And Has A Black Powdercoated Finish
- Strap Is Made With 4500 Lb Polyester Tie-down Webbing
- Sewn With Silver Polyester Thread
- Strap Length Is Measured As The Total Maximum Length When The Strap Is Fully Extended From The Frame
- Sewn In The Standard Method To Meet The Provided Strength Rating
- RS301 Van Rack Adapter Is A Single Bar Adapter With Custom Washers. The Adapter Has Pre-drilled Holes On One End To Mount The Adapter To The Ladder Rack Using The Provided Bolts And Custom Washers. The Opposite End Of The Adapter Has Pre-drilled Holes For Bolting On The Rack-Strap. The Van Adapter Is Designed To Fit Van Ladder Rack Models Such As
- Adrian Steel Cross Bar Only 1BRS, 2BRS Van Racks
- Rack-Strap Brand Strap Warning Label Sewn On The Hook End Of The Strap
- Includes The Bolt Mounting Kit For Installation
- Single Unit Box Packaging With Label
|
|
|
|
|
|
| Assembled By: Rack-Strap, Inc. |
|
| Product Weight: 5.24 lb per each |
|
2024-01-03
|
