RACK-STRAP TIE DOWNS

• Rack-strap, Rack-strap Tie-downs, J Hook On One End
• Rack-Strap Tie-Down, Mountable Ratchet Strap For Truck And Van Ladder Racks
• Mounting Bracket Can Be Bolted Or Welded Directly To The Ladder Rack So The Tie-down Permanently Mounted And Always Ready For Use
• For Proper Use, The Strap Is Pulled Out From The Spool, Fed Under The Ladder Or Cargo, Brought Back Over The Cargo Untill The Hook Reaches Back To The Rack-Strap Frame. The Hook Is Then Connected To The Frame On The Front Pin And Ratcheted Tight
• Rack-Strap Offers Two Tightening Options, The Provided Tightening Rod Or 1/2 Inch Nut On The End Of The Drive Axle
• The Black Knob Is Provided As A Method Of Winding Up The Loose Strap Or Removing Any Slack, But Never Use The Knob To Tighten The Tie-down
• Rack-Strap Mounting Bracket Is The Low Profile Right Angle Configuration That Fits Square Or Rectangular Tubing That Is 1 X 1 Inch Or Greater. Low Profile Is Designed To Fit Ladder Racks Where Clearance Between The Rack And Top Of The Vehicle Is Limited, Such As Mounting Over A Door Or Tool Box
• Rack-strap Frame Is Made Of Steel And Has A Zinc-yellow Plated Finish For Superior Weather Protection
• J Hook On The End Of The Strap Is The Double J Configuration And Has A Special Back Bend To Fit The Rack-Strap Frame
• Double J Hook Is Made Of Steel And Has A Zinc-yellow Plated Finish
• All Attached Rack-Strap Hardware Has A Zinc-yellow Plated Finish
• Strap Is Made With 4500 Lb Polyester Tie-down Webbing
• Sewn With Silver Polyester Thread
• Strap Length Is Measured As The Total Maximum Length When The Strap Is Fully Extended From The Frame
• Sewn In The Standard Method To Meet The Provided Strength Rating
• Rack-Strap Brand Strap Warning Label Sewn On The Hook End Of The Strap
• Includes The Bolt Mounting Kit For Installation