BOAT WINCH STRAPS - 2 INCH

• Tie-downs, Strap Extender, Flat Sewn Loop On One End, Snap Hook On Opposite End
• Strap Extender Configuration, Strap Only, Sewn To A Specific Length, Has No Tightening Mechanism
• 1 Inch Flat Sewn Loop On One End, Forged Eye Snap Hook On The Opposite End
• 1 Inch Flat Loop Can Be Attached To A Bolt Or To The Pin Inside A Boat Winch
• 1 Inch Flat Loops Have A Diameter Of 2 Inches And Can Fit Over A 1/2 Inch (0.50) Inch Diameter Bolt Or Pin
• Forged Eye Snap Hook Has A Retainer Clip That When Engaged Helps Prevent Unintentional Disconnects
• Heavy Duty Forged Snap Hook For High Strength And Durability
• Forged Snap Hook Is Made Of Steel And Has A Zinc-silver Plated Finish
• Snap Hook Is Forged, Slightly Thicker Than The Flat Version, And Is Orientated Parallel With The Strap Once Sewn
• Strap Is Made With 6000 Lb Seatbelt Style Polyester Webbing. Webbing Nominal Thickness Is 0.049 Inch (1.2mm)
• Sewn With Silver Polyster Thread
• Strap Length Is Measured As The Webbing Portion Only Including The Flat Sewn Loop, The Hook Is Not Included In The Measurement
• Sewn In The Standard Method To Meet Provided Strength Rating
• Webbing Eye Of The Snap Hook Has Less Than A 1 Inch Opening, But The Webbing Is 2 Inches Wide. Webbing Is Necked Down To Fit Through The Eye And Sewn
• CustomTieDowns Strap Warning Tag Sewn On The Hook End Of The Strap

• If Winding This Strap In A Boat Winch, Check That The Combination Of Strap Length And Webbing Thickness Will Fit In The Boat Winch When Wound Up