HOME

• Tie-downs, Strap Extender, Flat Sewn Loop On One End, Snap Hook On Opposite End
• Strap Extender Configuration, Strap Only, Sewn To A Specific Length, Has No Tightening Mechanism
• 1 Inch Flat Sewn Loop On One End, Flat Snap Hook On The Opposite End
• 1 Inch Flat Loop Can Be Attached To A Bolt Or To The Pin Inside A Boat Winch
• 1 Inch Flat Loops Have A Diameter Of 2 Inches And Can Fit Over A 1/2 Inch (0.50) Inch Diameter Bolt Or Pin
• Flat Snap Hook Has A Retainer Clip That When Engaged Helps Prevent Unintentional Disconnects
• Flat Snap Hooks Lay Flat When Sewn In The Same Orientation As The Webbing
• Commercial Duty Flat Snap Hook For High Strength And Durability
• Flat Snap Hook Is Made Of Steel And Has A Zinc-yellow Plated Finish
• Strap Is Made With 6000 Lb Polyester Seatbelt Webbing. Webbing Nominal Thickness Is 0.048 Inch (1.2mm)
• Sewn With Silver Polyster Thread
• Strap Length Is Measured As The Webbing Portion Only Including The Flat Sewn Loop, The Hook Is Not Included In The Measurement
• Sewn In The Standard Method To Meet Provided Strength Rating
• CustomTieDowns Strap Warning Tag Sewn On The Hook End Of The Strap

• If Winding This Strap In A Boat Winch, Check That The Combination Of Strap Length And Webbing Thickness Will Fit In The Boat Winch When Wound Up